Connection method 1: Connecting to a Wi-Fi network using the WPS button of a wireless router
If your wireless router has a WPS button, you can connect to the Wi-Fi network by the following method.
To check if your wireless router is compatible with WPS (Wi-Fi Protected Setup), refer to the operating instructions of your router.
Check the following before starting the operation.
- Disconnect the LAN cable from the speaker.
- Place the speaker near the wireless router.
- Set the Wi-Fi antenna on the rear in the upright position.
- Turn on the speaker.
The
(on/standby) indicator lights up in green, then the LINK indicator begins to flash. Wait until the LINK indicator stays lit or turns off. - Press and hold the WPS button on the rear of the speaker until a beep sound is heard.
The LINK indicator flashes in green.
- Press the WPS button of the wireless router for more than 3 seconds.
Operate within 90 seconds after pressing the WPS button of the speaker.
*The position and shape of the WPS button differ depending on the wireless router.
- Check that the LINK indicator changes from flashing to staying lit in green.
When the Wi-Fi connection is completed, the LINK indicator lights up in green.
The connection is complete.
If the LINK indicator lights up in red
The speaker failed to connect to the Wi-Fi network. Wait until the LINK indicator changes to staying lit in red, and try connecting again.
Hint
- For details on the WPS button of your wireless router, refer to its operating instructions.
- If the Wi-Fi connection fails even if you try several times, initialize the speaker and delete the setting information of the Wi-Fi connection, then try connecting again.
Note
- While a LAN cable is connected to the speaker, the speaker cannot connect to a Wi-Fi network.