Article ID : S500031675 / Last Modified : 11/04/2018

How to check and change the location of stored data on MovieShaker Version 3 and later?

Applicable Products and Categories of This Article

How to check and change the location of stored data on MovieShaker Version 3 and later?

Follow the steps below:
1. Start MovieShaker.
2. From the Edit menu, click Setting.
3. Click the location to store files tab.
4. Click Browse and browse to the required location to store the data.
5. Click OK.

Note:
To avoid lost frame or lost packet during the capturing process, store the captured file or temporary files to a hard disk drive (e.g. D drive) other than what contains the operating system. This will also prevent overlapped frame or lost packet at the time of export.