Article ID : S500012859 / Last Modified : 11/04/2018

When I try to capture the digital video data using the IEEE1394 interface, I cannot sometimes capture it normally only to see an error message on the screen.

Applicable Products and Categories of This Article

When I try to capture the digital video data using the
IEEE1394 interface, I cannot sometimes capture it normally
only to see an error message on the screen.

An error message is sometimes displayed, as some hard
disk drives do not have adequate transfer speed.
As some hard disk drive lacks in the transfer rate, an error
message appears at the time of capturing digital video
signals through the IEEE1394 interface and you sometimes
fail to capture them normally.
When it takes place, enable DMA if the hard disk drive
supports it and you can sometimes avoid this symptom.

For further details, refer to the following technical
information of the support of Microsoft.